5 May 2000
Alert 00 – 13 Lost Time Incident – Broken Finger WHAT HAPPENED: While attempting to remove the BOP remote closing unit from the rig floor during rig
- All
- 2007
- 2016
- Accreditation
- Advocacy
- Committees
- Conferences
- DRILLBITS
- Fall Prevention
- Fire Prevention
- First Aid
- General Safety
- Hand and Power Tools
- Health
- HSE
- Incident Prevention
- Industry Events
- Industry News & Resources
- Many Stories, One Voice
- Media Releases
- Membership
- Personal Protective Equipment
- Regional Chapters
- Rig Activities
- Safety Alerts
- Safety Meeting Topics
- Statements
- Student Chapters
- Uncategorized
- Weather
5 April 2000
Alert 00 – 11 Casing Stabbing Basket Incidents WHAT HAPPENED: A fatal incident occurred when an employee was folding up the standing platform of the stabbing basket while
6 October 1999
Alert 99 – 31 High Pressure Release of Trapped Nitrogen WHAT HAPPENED: Following the foam cementation of 20″ (50 cm) casing in deepwater from a semi-submersible rig,
6 October 1999
Alert 99 – 30 Marine Riser Buoyancy WHAT HAPPENED: While pulling the first section of marine riser through the drill floor, a section of buoyancy module weighing approximately
6 August 1999
Alert 99 – 26 Standing Under Suspended Load WHAT HAPPENED: A sub-sea engineer was fatally injured while working on a semi-submersible rig. The deceased was standing inside the
6 July 1999
Alert 99 – 21 Third Party Electrocution WHAT HAPPENED: Recently the configuration of an electrical connection on third party equipment contributed to a tragic fatality on board an
6 May 1999
Alert 99 – 15 Handrail Inspections and Safety WHAT HAPPENED: A rig was being rigged down and four employees were unhooking the mudline to stack out for transport.
6 April 1999
Alert 99 – 14 Rigging Down Safety WHAT HAPPENED: During rig-down, all sections of the mast had been dismantled and only the lower sections remained pinned to the
6 May 1998
Alert 98 – 19 Fall Protection WHAT HAPPENED: After being released from a daywork contract, the crew was preparing to move the rig to a new drill
